Menvier Security TSD401 Uživatelský manuál stáhnout pdf (Strana 24)

Menvier Security

Kenn Road Clevedon Avon BS21 6LH

Tel 01275 870078 Fax 01275 343453

E.Mail http//:www.menviersecurity.co.uk

TECHNICAL BULLETIN

NACOSS CODES OF PRACTICE NACP14

The following is intended to inform the you about the requirements of NACP14 and its affect on

you and the compatibility of MENVIER's range of control panels and accessories.

The following paragraph is taken from NACP 14

2.1.1 Facilities To Aid Filtering-Out Of False Calls

All alarm systems within the scope of practice shall either:

(a) have means to indicate to the alarm receiving centre whether the alarm

system is set or unset;

(b) be capable of generating a secondary signal to indicate to the alarm receiving

centre that the alarm system has been mis-operated.

In the case of alarm systems coming into operation on or before 31 December

1995 implementation of the above is deferred until 31 December 1996.

2.1.2 Means Of Completion Of Setting.

For all new alarm systems within the scope of this code of practice , coming into

operation on or after 1 January 1996 the completion of the full setting procedure

shall be achieved by means which involve positive action on the part of the

keyholder.

Translating the above into English, you will have to do the following on all

new systems

and

upgrade

existing systems

by 31 December 1996:

1. Send an open / close signal to the central station

Send the Central station an Abort Signal.

2. Fit exit terminator buttons or final exit shunt locks to all

new installations

NOTE. Any system fitted with a REDCARE

must

send open / close signal as the central

monitoring station will not police a no-response during the open state.

What must be appreciated is with the number of installations going in, the number of calls that

the central station are going to be processing will go through the roof. The answer would be to

only send the signal when needed which would be the ABORT signal. But you say how can my

existing jobs signal abort when the panel does not have the facility. The answer is to fit a

Menvier Abort Module which would be able to interface to your older / other control panels and

create an abort output for you.

1 2 ... 19 20 21 22 23 24 25 26

Žádné komentáře

Menvier Security TSD401 Uživatelský manuál Strana 24