Menvier Security TS400 Uživatelský manuál stáhnout pdf (Strana 29)

Troubleshooting

Alarm System troubleshooting

Problem - I enter my pas scode to set the system but the panel gives me an intermittent

soun d and th e display shows a zone is in fault.

Cause - The tone indicates that a detector is active or a door has been left open. The

display indicates which detector or door is active.

Action - Closedoors,wait10secondsandtryagain.Iftheproblempersistscontactyour

alarm company.

Problem - When Icame in and entered my passcodeth e displayshowsan alarm code and

gave an intermitten t beep.

Cause - Theindicationon thedisplayshows thealarm zonethatwas activatedwhenthe

system was set.

Action - Check the building for signs of a break in then refer to the section on Resetting

after an Alarm.

Problem - The panel beeps eve ry time I open certain doors or walk in front of movement

detectors.

Cause - The TSD402 has a facility called CHIME, which generates a two-tone sound

from the control panel every time certain zones are activated.

Action - To turn this facility on or off, see the section on Changing Chime Zones.

Problem - The display in dicates Au PL TA and the internal sounder ac tivates during the

unset condit ion.

Cause - Thisshowsthatthepanelhasdetectedan`Auxiliary'or`PanelLid'tamperfault,

i.e.awiringfault,acoverremovedfromadetectororcontrolpanel,orexternal

siren.

Action - Enter your passcode to silence the alarm then call your alarm company

immediately.

Problem - When the alarm was activated, the external siren pulsed.

Cause - The TSD402 has a facility to monitor smoke detectors. If one of these is

activated, the external siren will pulse to show that the alarm was caused by a

fire and not a burglar.

Action - Checkthesmokedetectortoensurethattheyareclearofsmoke.Iftheproblem

persists contact your alarm company.

TSD402 User Manual Troubleshooting

1 2 ... 24 25 26 27 28 29 30 31 32

Žádné komentáře

Menvier Security TS400 Uživatelský manuál Strana 29