Menvier Security TS510 Provozní pokyny stáhnout pdf (Strana 4)

5. SD1+ Connections

Before any connections are made to the SD1+ remove the power (battery and 240V

mains) from the control panel. Connections are provided as follows:

TRIG A: When triggered, the unit starts the dialling sequence and sends

message A.

TRIG B: When triggered, the unit starts the dialling sequence and sends

message B.

TRIG C: When triggered, the unit starts the dialling sequence and sends

message C.

ABORT / D: If the SD1+ is programmed as “ABORT by INPUT” this connection can

be used to abort the dialling sequence. If the SD1+ is not

programmed as “ABORT by INPUT” this connection can used as trigger

input D.

Trigger/Abort inputs can be selected to be either +ve applied to

trigger or -ve applied to trigger. Set the "Trigger Polarity" jumper-link to

the appropriate position.

TAMP: These two terminals can be connected to the main tamper zone on

the alarm control panel, to provide case tamper protection for the

SD1+.

0V: Connect to a permanent 0V supply on the control panel.

+12V: Connect to a permanent +12V supply on the control panel.

O/P1: A switched -ve @100mA programmable output.

Connections on the SD1+ are described as ether "Safety Extra-Low Voltage" circuits (SELV) or

"Telecommunication Network Voltages" circuits (TNV). Therefore it is important that installer

ensures that TNV circuits are only connected to the PSTN and SELV circuits are only

connected to other circuits designated as SELV circuits.

Please ensure that cabling to the telephone line connections (TNV) are routed well away

from the trigger input circuitry (SELV) and the cabling to the trigger input circuitry (SELV) are

routed well away from the telephone circuitry (TNV).

SD1+ SD1+

+12V +12V

TRIG POLARITY TRIG POLARITY

0V 0V

- -

TRIG A TRIG A

TRIG B TRIG B

TRIG C TRIG C

+12V on alarm

0V on alarm

resistor

N.C.

Loop

N.O.

Loop

N.O.

Loop

N.C.

Loop

TRIG A = Normally Closed Input

TRIG B = Normally Open Input

TRIG C = Switched +ve Input

TRIG A = Normally Open Input

TRIG B = Normally Closed Input

TRIG C = Switched -ve Input

1 2 3 4 5 6 7 8 9 ... 27 28

Komentáře k této Příručce

Žádné komentáře

Menvier Security TS510 Provozní pokyny Strana 4

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Menvier Security TS510