Menvier Security SD1 Uživatelský manuál stáhnout pdf (Strana 4)

2. Initialising the SD1

When the SD1 is switched on the display will show "PLEASE RE-RECORD" and the unit will beep

every 30 seconds. This indicates that the memory is blank (i.e., all telephone numbers and

messages are blank).

Displayshows"PLEASERE-RECORD"whenunit

is first switched on.

When initialised the display shows "READY",

the unit can now be programmed and

tested.

If the unit is not operated for 1 minute, it will

revert to its normal standby mode and the

display shows "-ON-".

3. Programming Telephone Numbers

The SD1 stores up to three telephone numbers with a maximum of 16 digits for each.

NOTE. Permission of the person(s) that are being called must be obtained before storing their

telephone number. The Emergency Services telephone numbers CANNOT be entered.

The following example shows how to set telephone number 1 as 081 1234567.

Ensure that the SD1 is initialised and the

display is showing "READY".

Pressing 1-3 selects telephone numbers 1, 2

or 3. 0-C selects phrases 0, A, B or C (see

section 4).

The display will alternate between "PHONE

No. 1" and the current telephone number

(Blank if the number has not been

programmed).

Pressing the A key will clear the display if a

mistakeismadewhilstenteringthenumber.

Repeat for telephone number 2 and 3 as

required.

Page 2

SD1 Operating Instructions

READY

Press the [ key for 6 secs

PLEASE RE-RECORD

Power switched on

-ON-

READY

ENTER 1-3 oOR 0-C

Press the [ key

PHONE NO 1

Select No. 1, 2 or 3

(e.g., Press 1 )

08112345 67

Enter telephone No.

(e.g., 0811234567)

Press the [ key to accept

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Menvier Security SD1 Uživatelský manuál Strana 4

Komentáře k této Příručce

Související produkty a manuály pro Systémy intercom pro domy Menvier Security SD1