Menvier Security SD1 Uživatelský manuál stáhnout pdf (Strana 11)

12. Trouble-Shooting Guide

Problem The unit will not dial the telephone number that I have programmed.

Cause Number incorrectly dialled

Action Check the telephone number you are calling has been entered correctly.

Problem When sending a Test call the display shows: N O R E P L Y

Cause The call was not answered or acknowledged by the recipient.

Action Ring the recipient and check they have followed the call acknowledgement

procedure.

Problem When sending a Test call the the display shows: E N G A G E D

Cause The recipient is on another call.

Action Wait until they have finished the call and try again.

Problem When sending a Test call the display shows: U N O B T A I N A B L E

Cause TheSD1hasdialledthenumber anddetected somethingother thana"ringing"

or "engaged" tone (e.g., a B.T. or Cellnet recorded message).

Action Check the number using a normal telephone or try again.

Problem The unit is triggered from the Control Panel but the display shows: - O N -

Cause This is the normal response.

Action If you require to see the SD1 status condition when triggered, the use the "Test

Activations" option (see section 8).

Problem When the unit callsthe recipient they can"tacknowledge the unit by pressing

the number [8] button.

Cause Incorrect acknowledgement procedure.

Action Instruct the recipient in the correct procedure (see section 6).

Cause Incompatible telephone.

Action Call the recipient and ask them to press the number [8] button on their

telephonefor 3 seconds. If youhear anything other than a3 second tone, their

telephone is not capable of acknowledging the SD1.

This may be overcome by using a tone pad to simulate the modern dialling

tones. Contact your installation company for further details.

Problem The recipient has acknowledged the call but the SD1 continues to dial the

second or third number.

Cause The"Acknowledgement Option" is set to "CLEAREDBY ANY 2" or "CLEARED BYALL

3".

Action Check the option is set to your required setting (see section 9).

Problem The SD1 "beeps" every 30 seconds and the display shows:

P L E A S E R E - R E C O R D

Cause The power supply to the SD1 has been interrupted.

Action Re-program all telephone numbers and messages as required (contact your

installation company for further advice if the the problem re-occurs).

Page 9

SD1 Operating Instructions

1 2 ... 6 7 8 9 10 11 12

Žádné komentáře

Menvier Security SD1 Uživatelský manuál Strana 11